| Lavanto® Program Features | Sink Options | Warranty | Installation |

Installing a TFI Lavanto® Corian® Vanity Top and Sink

These vanities are intended for simple drop-in installation. If the size of the vanity must be adjusted, contact your Lavanto® supplier for assistance. To install the vanity out of the carton:

• Remove the One-Piece Vanity Top & Sink from the cardboard container.
• Check for shipping damage or top surface defects. Report any problems to your Lavanto® supplier.
• Trial-fit the vanity to the cabinet wall. Adjust the cabinet and wall as required. The cabinet should support the vanity on either the cast in lugs or directly on the underside of the deck. Add shims if necessary.
• Determine the location of the faucet hardware using the template supplied with the faucet if holes have not been pre-drilled. Be sure the escutcheon plate will fit in the recessed ledge area.
• Drill the faucet holes and install the faucet hardware.
• Apply dabs of silicone every 8" to 12" along the top edge of the cabinet.
• Position the vanity onto the cabinet.
• Align the drainpipe with the sink drain hole.
• Apply the silicone to the underside of the drain cap. Install the cap.
• Install the overflow tube and mounting ring with the larger part of the ring against the bottom of the sink.
• Attach the drainpipe. Tighten the nut by hand. Then tighten with wrench ¼ additional turn. Do not overtighten.
• Install sidesplashes, if desired, by applying a thin bead of silicone to the bottom edge of the splash. Then push the splash into position. Apply another bead of silicone to seal where the splash meets the wall. Notice that there are left and right splashes. The sharper edges of the splashes should face the wall.
• Clean up with alcohol and a clean cloth.